|
Pelton
Turbine Test rig - BSPIL-HML-20006
a) Test rig consists of a pelton impulse wheel, designated for laboratory experimental purpose and to conduct test in metric units. The turbine is coupled to and alternator both mounted on a suitable collecting
tank.
1)design speed 1000/1400
RPM
2)Output Power 1.0 HP
The turbine consists of an M S body with suitable nozzle. A rotor assembly with shaft is connected to the alternator, all mounted on a sturdy base frame. The runner and nozzle are made of gunmetal for corrosion resistance. Water inlet pressure sis measured by pressure
gauge
b) Alternator and switchboard: Consists of a 1.0 KVA alternator coupled to the pelton turbine. Switchboard consists of a row of bulbs connected to the alternator. These bulbs act as load and could be switched on individually for varying the load. A ammeter and voltmeter are provided for measuring the load voltmeter are provided for measuring the load.
c) Water to the turbine is provided by a centrifugal monoblock pump set o;f 5 Hp capacity size 65 mm X 50 mm. The pump operates on 440 volts 3 phase 50 Hz
line.
d) Other standard accessories include a starter, flow control gatevalve and suitable
piping.
e) Flow measuring unit consists of a orifice/VENTURI meter of size 50 mm with pressure taps connected to two pressure gauges mounted on a panel
board.
f) The completer test rig is mounted on a storage tank of 500 litres capacity.The tank is provided with FRP lining for total rust protection. |
